Kia Rio Manuals

Kia Rio: Front Bumper Replacement - Bumper - Body (Interior and Exterior) - Kia Rio UB 2012-2025 Service ManualKia Rio: Front Bumper Replacement


     
•
Put on gloves to protect your hands.
•
Use a plastic panel removal tool to remove interior trip pieces to without marring the surface.
•
Take care not bend or scratch the cover and other parts.
1.
After loosening the mounting clips, then remove the radiator grille upper cover (A).
2.
Loosen the front bumper upper (A) mounting clips.
3.
After loosening the front bumper side’s mounting screw, then disconnect the side’s.
4.
Remove the front bumper lower mounting clips.
5.
Disconnect the fog lamp connector (A).
6.
Remove the front bumper cover (A).
7.
Installation is the reverse of removal.

     
•
Make sure the connector is plugged in properly.
•
Replace any damage clips.
Front Bumper Components
1 . Radiator grille upper cover 2 . Front bumper cover 3 . Front bumper side bracket [LH] 4 . Front bumper side bracket [RH] ...

Rear Bumper Components
[5 Door] 1. Rear bumper cover 2. Rear bumper side bracket [RH] 3. Rear bumper side bracket [LH] 4. Rear bumper side under cover [4 Door] ...

See also:

SS-B Solenoid Valve(ON/OFF) Description
SS-B solenoid valve is attached to the valve body and is an on/off solenoid valve that is used to change gears. SS-B Solenoid valve(ON/OFF) is installed at valve body. ...

Starter: Inspection
Starter Solenoid Inspection 1. Disconnect the lead wire from the M-terminal of solenoid switch. 2. Connect the battery as shown. If ...

Smart key unit Removal
Smart key unit [USA] 1. Disconnect the negative(-) battery terminal. 2. Remove the smart key unit (A) after disconnecting the c ...

Categories

Copyright www.kirmanual.com 2014-2025