Kia Rio: Seat Belt Buckle Switch (BS) Installation - SRSCM - Restraint - Kia Rio UB 2012-2024 Service ManualKia Rio: Seat Belt Buckle Switch (BS) Installation


     
Be sure to install the harness wires so they will not pinch or interfere with other parts.
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
3.
Install the seat belt buckle switch.

Tightening torque:
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~39.8 lb-ft)

4.
Install the front seat assembly.
(Refer to the Body group - "Front seat")
5.
Reconnect the battery negative cable.
6.
After installing the seat belt buckle switch, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator should be turned on for about six seconds and then go off.
Seat Belt Buckle Switch (BS) Removal
1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work. 2. Remove the front seat assembly. ...

Weight Classification System (WCS) Description
WCS is intended to detect the occupant’s physique in order to determine whether the passenger airbag should be suppressed or deployed. WCS classifies the front passenger side seat by measurin ...

See also:

Filler-Neck Assembly Installation
1. Installation is reverse of removal. Filler-neck assembly bracket installation nut : 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 ...

Description
System Overview The System offers the following features: - Human / machine interface through a 1-stage button, for terminal switching and engine start. ...

Heater & A/C Control Unit (FATC) Self Diagnosis
1. Self-diagnosis process 2. How to read self-diagnostic code During the self-diagnosis, the corresponding fault code flickers ...

Copyright © www.kirmanual.com 2014-2024