GMC Terrain: Setting the 3/4 Mode - Doors - Keys, Doors, and WindowsGMC Terrain: Setting the 3/4 Mode

To change the position the liftgate stops at when opening:

  1. Select MAX or 3/4 mode and power open the liftgate.
  2. Stop the liftgate movement at the desired height by pressing any liftgate switch. Manually adjust the liftgate position if needed.
  3. Press and hold pull cup on the bottom of the next to the
    pull cup on the bottom of the liftgate until the turn signals flash and a beep sounds. This indicates the setting has been recorded.

The liftgate cannot be set below a minimum programmable height. If there is no light flash or sound, then the height adjustment may be too low.

Obstacle Detection Features
If the liftgate encounters an obstacle during a power open or close cycle, the liftgate will automatically reverse direction and move a short distance away from the obstacle. After removing the o ...

Manual Operation
Select OFF to manually operate the liftgate. Caution Attempting to move the liftgate too quickly and with excessive force may result in damage to the vehicle. Operate the liftgate manually with a ...

See also:

Steering Wheel Adjustment
To adjust the steering wheel: Pull the lever down. Move the steering wheel up or down. Pull or push the steering wheel closer or away from you. Pull the lever up to lock the steering wheel ...

Auto Defogging Sensor (FATC only) Replacement
1. Remove the auto defogging sensor cover (A). 2. Disconnect the connector (B) and then remove the auto defogging sensor (C). ...

Component Location
1. Power door mirror 2. Power door mirror switch 3. Folding mirror switch ...

Copyright © www.kirmanual.com 2014-2021