Kia Rio: Side Airbag (SAB) Module Description
The Side Airbags (SAB) are installed inside the front seat and protects
the driver and passenger from danger when side crash occurs. The SRSCM determines
deployment of side airbag by using Side Impact Sensor (SIS) signal.
Never attempt to measure the circuit resistance of the airbag
module (squib) even if you are using the specified tester. If the circuit
resistance is measured with a tester, accidental airbag deployment will
result in serious personal injury.
|
Passenger Airbag (PAB) ModuleInstallation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable from battery and wait for
at least thirty seconds bef ...
See also:
Underdrive Brake Control Solenoid Valve(UD/B_VFS) Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require
additional hydraulic pressure adjustment; however, the ...
AVN Head Unit Components
AVN (A/V & Navigation) Head Unit Connector
NO
Connector A
Connector B
1
Rear left spearker +
-
2
Front left ...
Washer fluid
Checking the washer fluid level
Check the fluid level in the washer fluid reservoir and add fluid if necessary.
Plain water may be used if washer fluid is not available.
However, use washer sol ...
Copyright © www.kirmanual.com 2014-2021