Kia Rio: Side Airbag (SAB) Module Removal
The side airbag cannot be disassembled from the seat back assembly,
so replace the seat back assembly when replacing the side airbag.
|
| 1. |
Disconnect the battery negative cable and wait for at least thirty
seconds before beginning work.
|
| 2. |
Remove the front seat assembly.
(Refer to the Body group - "Seat")
|
| 3. |
Remove the seat back assembly.
(Refer to the Body group - "Seat")
|
Side Airbag (SAB) Module Installation
Be sure to install the harness wires so they will not pinch or
interfere with other parts.
...
See also:
Antenna Coil Installation
1.
Install the antenna coil.
2.
Connect the antenna coil connector.
3.
Install the crash pad lower panel.
...
Specification
Item
Specification
Capacitance (pF)
950 ~ 1,350
Resistance (MΩ)
4.87
...
Rain Sensor Inspection
Rain Sensing Wiper
1.
In IGN2 ON state, if auto switch input (LIN communication) is
ON then both wiper low relay and wiper high relay outputs are controlled
by the ...
Copyright © www.kirmanual.com 2014-2019