Kia Rio: Specification
Air Conditioner
| Item |
Specification |
|
| Compressor |
Type |
DVE12 (Externally Controlled Variable Swash Plate Type) |
| Oil type & Capacity |
PAG OIL, 120±10 cc |
|
| Displacement |
122 cc/rev |
|
| Condenser |
Heat Rejection |
11,900 - 3% kcal/h |
| Expansion valve |
Type |
Block type |
| Refrigerant |
Type |
R-134a |
| Capacity |
470 ± 25 g (16.5 ± 0.88 oz.) |
|
Blower Unit
| Item |
Specification |
|
| Intake |
Control Type |
Actuator |
| Blower |
Type |
Sirocco |
| Speed Step |
FATC: Auto or 1~8 speed, MANUAL: 1~4 speed |
|
| Speed Control |
FATC: Power mosfet, MANUAL: Blower resistor |
|
| Air filter |
Type |
Particle filter |
Heater And Evaporator Unit
| Item |
Specification |
|
| Heater |
Type |
Pin & Tube type |
| Heating Capacity |
4,650 - 5% kcal/hr |
|
| Mode Control Type |
Actuator |
|
| Temperature Control Type |
Actuator |
|
| Evaporator |
Cooling Capacity |
4,500 - 5% kcal/hr |
| Temperature Control Type |
Evaporator temperature sensor |
|
| A/C ON/OFF |
ON: 0 ± 0.3°C (32.0 ± 0.5°F) OFF: -2.0 ± 0.3°C (28.4 ± 0.5°F) |
|
Tightening Torques
| Items |
N.m |
kgf.m |
lb-ft |
| Compressor |
19.6 ~ 33.3 |
2.0 ~ 3.4 |
14.5 ~ 24.6 |
| Condenser - Discharge hose |
4.9 ~ 5.9 |
0.5 ~ 0.6 |
3.6 ~ 4.3 |
| Condenser - Liquid tube |
|||
| Compressor - Discharge hose |
4.9 ~ 5.9 |
0.5 ~ 0.6 |
3.6 ~ 4.3 |
| Compressor - Suction hose |
|||
| Expansion valve - Evaporator |
11.8 ~ 14.7 |
1.2 ~ 1.5 |
8.7 ~ 10.9 |
Troubleshooting
Problem Symptoms Table
Before replacing or repairing air conditioning components, first determine
if the malfunction is due to the refrigerant charge, air flow or compressor.
Us ...
See also:
Description
The Evaporative Emission Control System prevents fuel vapor stored in
fuel tank from vaporizing into the atmosphere. When the fuel evaporates in the
fuel tank, the vapor passes through vent h ...
Description
The starting system includes the battery, starter, solenoid switch, ignition
switch, inhibitor switch (A/T), clutch pedal switch (M/T), ignition lock switch,
connection wires and the battery ...
Oil Pump Unit (OPU) Inspection
OPU Problem Inspection Procedure
1.
TEST OPU GROUND CIRCUIT: Measure resistance between OPU and chassis
ground using the backside of OPU harness connector ...
Copyright © www.kirmanual.com 2014-2020