Kia Rio: Temperature Control Actuator Inspection| 1. |
Turn the ignition switch OFF.
|
| 2. |
Disconnect the temperature control actuator connector.
|
| 3. |
Verify that the temperature control actuator operates to the warm
position when connecting 12V to terminal 3 and grounding terminal 4.
Verify that the temperature control actuator operates to the cool
position when connecting in the reverse.
|
| 4. |
Connect the temperature control actuator connector.
|
| 5. |
Turn the ignition switch ON.
|
| 6. |
Check the voltage between terminal 6 and 5.
Specification
It will feedback current position of actuator to controls.
|
| 7. |
If the measured voltage is not within specification, substitute
with a known-good temperature control actuator and check for proper
operation.
|
| 8. |
Replace the temperature control actuator if it is proved that
there is a problem with it.
|
Temperature Control Actuator Description
Temperature Control Actuator ReplacementLow brake fluid level warning
If the warning light remains on, it may indicate that the brake fluid level in
the reservoir is low.
If the warning light remains on:
1.Drive carefully to the nearest safe location and stop your v ...
Circuit Diagram
...
Wipers & Washers
A : Wiper speed control (front)
HI – High wiper speed
LO – Low wiper speed
INT – Intermittent wipe
AUTO– Automatic control wipe
OFF – Off
MIST – Single wipe
B : Intermit ...