Kia Rio Manuals

Kia Rio: Torque Converter Control Solenoid Valve (T/CON_VFS) Installation - Automatic Transaxle Control System - Automatic Transaxle System - Kia Rio UB 2012-2020 Service ManualKia Rio: Torque Converter Control Solenoid Valve (T/CON_VFS) Installation

1.
Installation is the reverse of removal.

     
•
The gasket of the valve body gasket (A) use new one.
•
Adding automatic transaxle fluid.
(Refer to "Hydraulic system (Fluid)" in this group)


•
Perform TCM learning after replacing the automatic transaxle to prevent slow automatic transaxle response, jerky acceleration and jerky startup.
(Refer to "Automatic transaxle control system (Repair procedures)" in this group)
Torque Converter Control Solenoid Valve (T/CON_VFS) Removal
1. Remove the battery and the battery tray. (Refer to "Charging system" in EE group.) 2. Remove the under cover (A). ...

26 Brake Control Solenoid Valve(26/B_VFS) Description
26 brake control solenoid valve(26/B_VFS) is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the 26 brake. ...

See also:

Fuses
A vehicle’s electrical system is protected from electrical overload damage by fuses. This vehicle has 2 fuse panels, one located in the driver’s side panel bolster, the other in the engine comp ...

Installation
Installation is the reverse of removal. Canister installation bolt/nut: 19.6 ~ 29.4 N.m (2.0 ~ 3.0 kgf.m, 14.5 ~ 21.7 lb-ft) ...

Rear Hub - Carrier Replacement
[Drum Type] 1. Remove the rear wheel & tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) ...

Categories

Copyright © www.kirmanual.com 2014-2020