1. |
Check that the red light flickers when the door lock or unlock
button is pressed on the transmitter.
|
2. |
Remove the battery and check voltage if the red light doesn't
flicker.
|
3. |
Insert the battery (A) into the tester (09954-2p100).
|
4. |
Push the test button and If "0.00" is displayed on screen, it
means that the battery voltage is 2V or less.
|
5. |
If "L" is displayed on screen, it means that the battery is low
power and it needs to replace.
|
6. |
To prevent the discharge of electricity, turn the tester power
off.
|
7. |
Replace the transmitter battery with a new one, if voltage is
low power then try to lock and unlock the doors with the transmitter
by pressing the lock or unlock button five or six times.
|
8. |
If the doors lock and unlock, the transmitter is O.K, but if the
doors don't lock and unlock, register the transmitter code, then try
to lock and unlock the doors.
|
9. |
If the doors lock and unlock, the transmitter is O.K, but if the
doors don't lock and unlock, replace the transmitter.
|
Component Location
1. Head cap
2. Nut
3. Rear wiper arm & Blade
4. Packing (rubber)
5. Rear wiper motor assembly
6. Bolt
...
Output Speed Sensor Specifications
▷ Type: Hall effect sensor
Operation condition [°C(°F)]
((-)40 ~ 150)) -40 ~ 302
Air gap(mm)in.
(0.85 ~ 1.3)
0.0335 ~ 0.0512
Output volt ...
Starter: Description
The starting system includes the battery, starter, solenoid switch, ignition
switch, inhibitor switch (A/T), clutch pedal switch (M/T), ignition lock switch,
connection wires and the battery ...