Kia Rio: Windshield Wiper-Washer Switch Removal
Wiper and Washer Switch
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the steering wheel.
(Refer to the ST group - "Steering column & shaft")
|
| 3. |
Remove the steering column upper (A) and lower (B) shrouds after
removing the screw.
|
| 4. |
Disconnect the connector(A). Release the lock of wiper switch
using tool without removing the steering wheel and the clock spring.
Remove the wiper and washer switch.
|
Windshield Wiper-Washer Switch Inspection
Wiper And Washer Switch Inspection
With the multifunction switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified, replace
...
Windshield Wiper-Washer Switch Installation
1.
Install the wiper switch.
2.
Install the steering column upper and lower shrouds.
...
See also:
Special Service Tools
Tool (Number and name)
Illustration
Use
Alternator pulley remover wrench
(09373-27000)
Removal and installation of alternator pulley
...
Circuit Diagram
(M/T)
(A/T)
...
CVVT (Continuously Variable Valve Timing) System: [CVVT System Mode]
(1) Low Speed / Low Load
(2) Part Load
(3) Low Speed / High Load
(4) High Speed / High Load
...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2026 Owners Manual
- Kia Rio YB 2017-2026 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2026