Kia Rio: A/C Pressure Transducer Replacement - Air Conditioning System - Heating,Ventilation, Air Conditioning - Kia Rio UB 2012-2026 Service ManualKia Rio: A/C Pressure Transducer Replacement

1.
Disconnect the negative (-) battery terminal.
2.
Recover the refrigerant with a recovery/charging station.
3.
Disconnect the A/C pressure transducer connector (A).


4.
Remove the A/C pressure transducer (A).

Tightening torque:
10~12 N.m (1.02~1.22 kgf.m, 7.4~8.8 lb-ft)



     
Take care that liquid & suction pipe are not bent.
5.
Install in the reverse order of removal.



     
When installing, replace with new O-ring (A).
A/C Pressure Transducer Inspection
1. Measure the pressure of high pressure line by measuring voltage output between terminal “1” and “2”. 2. Inspect the volt ...

Evaporator Temperature Sensor Description
The evaporator temperature sensor will detect the evaporator core temperature and interrupt compressor relay power in order to prevent evaporator freezing by excessive cooling. ...

See also:

Rear combination lamp Removal
Rear combination lamp (Inside) [4 Door] 1. Disconnect the negative (-) battery terminal. 2. Remove the trunk trim. (Ref ...

Ignition Coil: Specification
Item Specification Primary Coil Resistance (Ω) 0.75 ± 15% [20°C (68°F)] Secondary Coil Resistance (kΩ) 5.9 ± 15% ...

Specifications
Item Specification Power source DC 14.4V (-) ground Frequency range / Channel space FM : 87.5 ~ 107.9 MHz / 200 K AM : 530 ~ 1710 KHz / 10 K ...

Copyright www.kirmanual.com 2014-2026