Kia Rio: Adjustment
| Clutch Release Cylinder Air Bleeding Procedure |
Use the specified fluid. Avoid mixing different brands of fluid.
|
Specified fluid: SAE J1703
(DOT 3 or DOT 4)
|
| 1. |
After disconnecting a cap from the clutch release cylinder air
bleeder, insert a vinyl hose in the plug.
|
| 2. |
Loosening the plug screw, press and release the clutch pedal about
10 times.
|
| 3. |
Tighten the plug (A) during the clutch pedal pressed. Afterwards,
raise the pedal with a hand.
|
| 4. |
After pressing the clutch pedal 3 times more, loosen the plug
(A) and retighten it with the pedal pressed. Raise it again, then.
|
| 5. |
Repeat the step 4 two or three times. (until there is no bubble
in the fluid)
|
| 6. |
Refill the clutch master cylinder with the specified fluid.
|
Installation
1.
Installation is the reverse of removal.
Coat the clutch clevis push r ...
See also:
Description
Continuous Variable Valve Timing (CVVT) system advances or retards the
valve timing of the intake and exhaust valve in accordance with the ECM control
signal which is calculated by the engine ...
Servicing The Electrical System
1.
Prior to servicing the electrical system, be sure to turn off
the ignition switch and disconnect the battery ground cable.
&nb ...
Circuit Diagram
Hamess Connector
Pin No.
Discription
Remark
1
-
2
-
3
-
4
...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2026 Owners Manual
- Kia Rio YB 2017-2026 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2026