Kia Rio Manuals

Kia Rio: Alternator: Removal and installation - ISG (Idle Stop & Go) System - Engine Control / Fuel System - Kia Rio UB 2012-2026 Service ManualKia Rio: Alternator: Removal and installation

1.
Disconnect the battery negative terminal first, then the positive terminal.
Tightening torque
(+) terminal :
7.8 ~ 9.8N.m (0.8 ~ 1.0kgf.m, 5.8 ~ 7.2lb-ft)
(-) terminal (without battery sensor):
7.8 ~ 9.8N.m (0.8 ~ 1.0kgf.m, 5.8 ~ 7.2lb-ft)
(-) terminal (with battery sensor):
4.0 ~ 6.0N.m (0.4 ~ 0.6kgf.m, 3.0 ~ 4.4lb-ft)
2.
Remove the drive belt.
(1)
Loosen the through bolt (A).
(2)
Loosen the tension by turning the tension adjusting bolt (B).
(3)
Remove the drive belt (A).
3.
Disconnect the A/C compressor switch connector (A), the alternator connector (B) and the cable from the alternator "B" terminal (C).
4.
Remove the alternator (A).
Tightening torque :
19.6~26.5 Nm (2.0~2.7 kgf.m, 14.5~19.5 Ib-ft)-12mm bolt
29.4~41.2 Nm (3.0~4.2 kgf.m, 21.7~30.4 Ib-ft)-14mm bolt


5.
Installation is the reverse order of removal.
6.
Adjust the alternator belt tension after installation.
Alternator: On-vehicle Inpection
   • Check that the battery cables are connected to the correct terminals. ...

Starter: Description
The starting system includes the battery, starter, solenoid switch, inhibitor switch (A/T), ignition switch, ignition lock switch, connection wires and the battery cable. When the ignitio ...

See also:

Speakers Removal
Front Speaker 1. Remove the front door trim panel. (Refer to the BD group - "Front door") 2. Remove the front speaker (A) ...

Relay Box (Passenger Compartment) Fuse Inspection
1. Be sure there is no play in the fuse holders, and that the fuses are held securely. 2. Are the fuse capacities for each circuit correct? ...

Installation
1. Installation is the reverse of removal. 2. After installation, bleed the brake system. (Refer to Brake system bleeding) ...

Categories

Copyright www.kirmanual.com 2014-2026