Kia Rio: Auto Defogging Sensor (FATC only) Description

The Auto Defogging Sensor is installed on the front windshild glass. The Auto Defogging Sensor senses moisture on the windshild. The air conditioner control module receives the signal from the sensor and eliminates fog by controlling the intake actuator, A/C, auto defogging actuator, blower motor rpm, and mode actuator.

Ambient Temperature Sensor Replacement

1. Disconnect the negative (-) battery terminal. 2. Remove the engine room RH side under cover. (Refer to EM group - “Engine and Trans ...

Auto Defogging Sensor (FATC only) Inspection

1. Press the MODE switch more then 4 times within 2 seconds while pressing the OFF switch. Display Fail description 00 ...

See also:

Power Door Lock Switch Installation
1. Install the power window switch module. 2. Install the door trim panel after reconnecting the relevant connectors ...

Rear combination lamp Removal
Rear combination lamp (Inside) [4 Door] 1. Disconnect the negative (-) battery terminal. 2. Remove the trunk trim. (Ref ...

Description
Intake Air Temperature Sensor (IATS) is included inside Manifold Absolute Pressure Sensor and detects the intake air temperature. To calculate precise air quantity, correction of the air tem ...