Kia Rio: Battery Caution Label Description

| A. Keep lighted cigarettes and all other flames or sparks away from the battery. |
| B. Wear eye protection when charging or working near a battery. Always provide ventilation when working in an enclosed space.
|
|||||
| C. Keep batteries out of the reach of children because batteries contain highly corrosive SULFURIC ACID. Do not allow battery acid to contact your skin, eyes, clothing or paint finish. |
| D. If any electrolyte gets into your eyes, flush your eyes with clean water for at least 15 minutes and get immediate medical attention. If possible, continue to apply water with a sponge or cloth until medical attention is received. If electrolyte gets on your skin, throughly wash the contacted area. If you feel a pain or a burning sensation, get medical attention immediately. |
| E. Always read the following instructions carefully when handing a battery. |
| F. Hydrogen, which is a highly combustible gas, is always presents in battery cells and may explode if ignited. |
| G. An improperly disposed battery can be harmful to the environment and human health. Always confirm local regulations for battery disposal. |
| Battery Itself |
|
||||
| Battery on Vehicle |
|
||||
After reconnecting or recharging a discharged battery, the ESC
OFF indicator may illuminate.
In this case, turn the handle half way to the left and right whilst
the ignition switch is in the ON position.
Then, restart the engine after the ignition is OFF.
The ESC OFF indicator may turn OFF.
If the ESC OFF indicator does not turn OFF, have the system checked
refering to DTC.
|
Warning / Caution Label Locations
Lift And Support PointsSeat Belt Switch Inspection
1.
Remove the connector from the switch.
2.
Check for continuity between terminals.
Seat belt condition
Continu ...
Driver Airbag (DAB) Module and Clock Spring Inspection
Driver Airbag (DAB)
If any improper parts are found during the following inspection, replace
the airbag module with a new one.
...
A/C Pressure Transducer Inspection
1.
Measure the pressure of high pressure line by measuring voltage
output between terminal “1” and “2”.
2.
Inspect the volt ...