Kia Rio: Delivery Pipe Installation
| •
|
Do not use already used injector fixing clip again.
|
|
|
Do not reuse the support disc.
Do not reuse the injector rubber washer.
Do not reuse the combustion seal.
|
| •
|
Install the component with the specified torques.
|
| •
|
Note that internal damage may occur when the component
is dropped. In this case, use it after inspecting.
|
|
| •
|
Apply engine oil to the injector O-ring.
|
| •
|
Do not use already used injector O-ring again.
|
|
| •
|
Do not use already used bolt again.
|
|
| •
|
When insert the injector, be careful not to damage the
injector tip.
|
|
|
1. |
Installation is reverse of removal.
Delivery pipe installation bolt:
18.6 ~ 23.5 N.m (1.9 ~ 2.4 kgf.m, 13.7 ~ 17.4 lb-ft)
High pressure fuel pipe installation
nut:
26.5 ~ 32.4 N.m (2.7 ~ 3.3 kgf.m, 19.5 ~ 23.9 lb-ft)
|
|
In case of removing the high pressure fuel pump, high pressure
fuel pipe, delivery pipe, and injector, there may be inju ...
In case of removing the high pressure fuel pump, high pressure
fuel pipe, delivery pipe, and injector, there may be inju ...
See also:
TPMS Receiver Diagnosis procedure by using diagnostic device
As manual for diagnosis methods by using diagnosis device, the main contents
are as follows:
1.
Connect self-diagnosis connector(16pins) located in the lower
of driv ...
Oil Pump Unit (OPU) Connector
Opu Connector Terminal Function
EGGG114-A
EGGG114-B
Pin No.
Description
Pin No.
Description
1
Motor power(W)
...
Description
The starting system includes the battery, starter, solenoid switch, ignition
switch, inhibitor switch (A/T), clutch pedal switch (M/T), ignition lock switch,
connection wires and the battery ...
Delivery Pipe Removal
High Pressure Fuel Pump Removal