Kia Rio: Foot Actuator (With Auto Defogging System) Replacement
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the glove box housing.
(Refer to BD group - “Crash pad”)
|
| 3. |
Remove the cluster ionizer.
(Refer to HA group - “Cluster Ionizer”)
|
| 4. |
Disconnect the connector (A) and then remove the foot actuator
(B) after loosening the mounting screws.
|
| 5. |
Install in the reverse order of removal.
|
Foot Actuator (With Auto Defogging System) Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the foot connector.
3.
Verify that the foot actuator operates to ...
Blower
...
See also:
Record your key number
The key code number is stamped on the key code tag attached to the key set. Should
you lose your keys, this number will enable an authorized Kia dealer to duplicate
the keys easily.
After reco ...
Steering Angle Sensor (MDPS Only) Description
The Steering Angle Sensor (SAS) is installed in MDPS (Motor Driven Power
Steering) and it sends messages to HECU through CAN communication line.
The SAS is used to determine turning directio ...
TJ Joint Installation
1.
Wrap tape around the driveshaft spline(TJ) to prevent damage to
the boot.
2.
Using the alignment marks (D) made during disassembly as a ...
Copyright © www.kirmanual.com 2014-2025