Kia Rio Manuals

Kia Rio: Front Impact Sensor (FIS) Removal - SRSCM - Restraint - Kia Rio UB 2012-2026 Service ManualKia Rio: Front Impact Sensor (FIS) Removal


     
•
Removal of the airbag must be performed according to the precautions/ procedures described previously.
•
Before disconnecting the front impact sensor connector, disconnect the front airbag connector(s).
•
Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact sensor.
1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Remove the front wheel guard.
(Refer to the Body group - "Exterior")
3.
Left side - Remove the air duct assembly.
Right side - Remove the washer reservoir.
(Refer to the Body Electrical group - "Washer motor")
4.
Remove the front impact sensor (B) mounting bolt.
5.
Disconnect the front impact sensor connector (A).
6.
Remove the front impact sensor.
Front Impact Sensor (FIS) Components
...

Front Impact Sensor (FIS) Installation
   • Do not turn the ignition switch ON and do not contact the battery cable while replac ...

See also:

Specification
[Throttle Position Sensor (TPS)] Throttle angle(°) Output Voltage (V) TPS1 TPS2 0 0.5 4.5 10 0.96 4.05 ...

Dynamic Damper Installation
1. Apply soap powder on the shaft to prevent being damaged between the shaft spline and the dynamic damper. 2. Install the dynamic damper. ...

Blower Unit Component Location
...

Categories

Copyright www.kirmanual.com 2014-2026