Kia Rio: Front Washer Motor Installation

1.

Install the washer reservoir.

Before installing the pump motor, check the filter for foreign material or contamination. if necessary, clean the filter into the pump motor.

2.	Install the washer motor.

3.	Install the washer hose.

4.	Connect the washer motor connector.

5.	Install the front wheel guard (RH).

6.	Check the washer motor operation.

Front Washer Motor Removal

- When servicing the washer pump, be careful not to damage the washer pump seal. ...

Rain Sensor Circuit Diagram

...

See also:

ESC OFF Switch Inspection
1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the crash pad lower panel. (Refer to the Body ...

SS-A Solenoid Valve(ON/OFF) Description
SS-A solenoid valve is attached to the valve body and is an on/off solenoid valve that is used to change gears. SS-A Solenoid valve(ON/OFF) is installed at valve body. ...

Input Speed Sensor Inspection
1. Check signal waveform of Input & output speed sensor using the GDS. Specification: Refer to "Signal Wave Form" section. ...

Categories

Copyright © www.kirmanual.com 2014-2026