Kia Rio: Hazard warning flasher   lighting - Instrument cluster - Features of your vehicle - Kia Rio UB 2012-2026 Owners ManualKia Rio: Hazard warning flasher   lighting

The hazard warning flasher should be used whenever you find it necessary to stop


The hazard warning flasher should be used whenever you find it necessary to stop the car in a hazardous location. When you must make such an emergency stop, always pull off the road as far as possible.

The hazard warning lights are turned on by pushing in the hazard switch. Both turn signal lights will blink. The hazard warning lights will operate even though the key is not in the ignition switch.

To turn the hazard warning lights off, push the switch again.

Battery saver function

If necessary, to keep the lights on when the ignition key is removed, perform the following :

1) Open the driver-side door.

2) Turn the parking lights OFF and ON again using the light switch on the steering column.

Lighting control


Rear-camera display
The Rear-Camera Display will activate when the back-up light is ON with the ignition switch ON and the shift lever in the R (Reverse) position. This system is a supplemental system that displays ...

Lighting control
The light switch has a Headlight and a Parking light position. To operate the lights, turn the knob at the end of the control lever to one of the following positions: (1) OFF position (2) Parking ...

See also:

TJ Joint Components
[LH] 1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot 5. Shaft 6. TJ boot band 7. TJ boot 8. Spider assembly 9. Snap ring 10. TJ c ...

Troubleshooting
Symptom Suspect area Engine will not start or hard to start Vapor hose damaged or disconnected Engine struggles to start Malfunction of the Pu ...

Installation
1. Installation is the reverse of removal.    Use a new washer (A) whenever ...

Copyright www.kirmanual.com 2014-2026