1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the heater & A/C controller (A) from the center facia using
a flat-head screwdriver or remover.
|
3. |
Disconnect the connectors (A) and the air hose (B).
|
4. |
Install in the reverse order of removal.
|
Anchor Pretensioner (APT) Description
Front seat belt anchor pretensioner operates as well as belt pretensioner
at the same time If it gets into its deploy condition after a collision. It
is located at near anchor on front seat a ...
Specification
Accelerator
Position
Output Voltage (V)
APS1
APS2
C.T
0.7 ~ 0.8
0.275 ~ 0.475
W.O.T
3.8 ~ 4.4
1.75 ~ 2.35 ...
Compression Pressure Inspection
If there is lack of power, excessive oil consumption or poor fuel
economy, measure the compression pressure.
...