Kia Rio: Ignition Coil: Removal - Ignition System - Engine Electrical System - Kia Rio UB 2012-2026 Service ManualKia Rio: Ignition Coil: Removal

1.
Disconnect the battery nagative terminal.
2.
Remove the engine cover.
3.
Disconnect the ignition coil connector (A).



     
When removing the ignition coil connector, pull the lock pin (A) and push the clip (B).


4.
Remove the ignition coil (A).


Ignition Coil: Circuit Diagram
...

Ignition Coil: Installation
1. Install in the reverse order of removal. Ignition coil installation bolts: 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 Ib-ft) ...

See also:

Blower Resistor (MANUAL) Inspection
1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replac ...

Transaxle Control Module (TCM) Replacement
   When replacing the TCM, the vehicle equipped with immobilizer must be performed the procedure as below. [In the ...

Heater & A/C Control Unit (MANUAL) Schematic Diagram
...

Copyright www.kirmanual.com 2014-2026