Kia Rio: Inspection - Injector - Engine Control System - Engine Control / Fuel System - Kia Rio UB 2012-2023 Service ManualKia Rio: Inspection

1.
Turn the ignition switch OFF.
2.
Disconnect the injector connector.
3.
Measure resistance between the injector terminals 1 and 2.
4.
Check that the resistance is within the specification.

Specification: Refer to “Specification”

Circuit Diagram
(M/T) (A/T) ...

Removal
   In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be inju ...

See also:

Rear Coil Spring Replacement
1. Remove the rear wheel & tire. (Both RH side and LH side) Tightening torque : 88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb ...

Brake Booster Operating Test
For simple checking of the brake booster operation, carry out the following tests. 1. Run the engine for one or two minutes, and then stop it. If the pedal depresses ...

Oil Pump Description
The oil pump is built-in as a single unit with the 26 brake chamber. Rotation of the pump builds the hydraulic pressure needed for the lubrication of the various parts of the transaxle and op ...

Copyright © www.kirmanual.com 2014-2023