Kia Rio: Inspection - Fuel Pressure Control Valve - Engine Control System - Engine Control / Fuel System - Kia Rio UB 2012-2026 Service ManualKia Rio: Inspection

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the fuel pressure regulator valve connector.
3.
Measure resistance between the fuel pressure regulator valve terminals 1 and 2.
4.
Check that the resistance is within the specification.

Specification: Refer to “Specification”

Circuit Diagram
(M/T) (A/T) ...

Canister Close Valve (CCV)
...

See also:

Rear combination lamp Installation
Rear combination lamp (Inside) [4 Door] 1. Install the rear combination lamp assembly. 2. Connect the rear combination connecto ...

Description
The Alternator has eight built-in diodes, each rectifying AC current to DC current. Therefore, DC current appears at alternator "B" terminal. In addition, the charging voltage ...

Starter: Components
1. Screw 2. Front housing 3. Stop ring 4. Stopper 5. Overunn clutch 6. Lever 7. Lever plate 8. Lever packing 9. Magnet switch assembly 10. Armature assemb ...

Copyright www.kirmanual.com 2014-2026