1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the crash pad.
(Refer to BD group - "Crash Pad")
|
3. |
Remove the side bracket (A).
|
4. |
Disconnect the connector (A) and then remove the intake actuator
(B) after loosening the mounting screws.
|
5. |
Install in the reverse order of removal.
|
Driver Airbag (DAB) Module and Clock Spring Inspection
Driver Airbag (DAB)
If any improper parts are found during the following inspection, replace
the airbag module with a new one.
...
Wheel Hub Nut Tightening Sequence
Tighten the hub nuts as follows.
Tightening torque :
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
...
Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector.
3.
Measure resistance between sensor ...