Kia Rio: Mode Control Actuator Replacement
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the crash pad.
(Refer to BD group - "Crash Pad")
|
| 3. |
Remove the BCM unit.
(Refer to BE group - "BCM")
|
| 4. |
Disconnect the connector (A) and then remove the mode control
actuator (B) after loosening the mounting screws.
|
| 5. |
Install in the reverse order of removal.
|
Mode Control Actuator Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the mode control actuator connector.
3.
Verify that the mode con ...
Foot Actuator (With Auto Defogging System) Description
The foot actuator is located at the heater unit. It adjusts position of
the foot door in heater unit of the vehicle equipped with the auto defogging
system. ...
See also:
Component(1)
※ Installation order : A → B → C → D → E
1. Steering column shaft
2. Lighting switch
3. Wiper and washer switch
4. Screw
5. Steering angle ...
Emission control system
The emission control system of your vehicle is covered by a written limited warranty.
Please see the warranty information contained in the Warranty & Maintenance booklet
in your vehicle.
Your ...
Output Speed Sensor Inspection
1.
Check signal waveform of Input & output speed sensor using the
GDS.
Specification:
Refer to "Signal Wave Form" section.
...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2025 Owners Manual
- Kia Rio YB 2017-2025 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2025