Kia Rio Manuals

Kia Rio: Parking Brake Adjustment - Rear Disc Brake - Brake System - Kia Rio UB 2012-2026 Service ManualKia Rio: Parking Brake Adjustment


     
•
Re-setting of the parking brake is necessary after overhauling the caliper body, or if the brake calipers, housing, parking brake cable or brake discs have been changed.
1.
Remove the floor console to reach the adjusting nut.
2.
Loosen the parking brake cable until both operating levers rest in fully off position.
3.
Bring the brake pads in their operating position by pressing the brake pedal down several times until there is resistance.
4.
Tension the parking brake cable by tightening the adjusting nut, until the operating levers on both calipers lift from the stop, up to a distance of (A) between operating lever (B) and stopper (C).
Distance (A): Max. 1.5 mm (0.06 in)


5.
Parking brake lever in the car must be in fully loosened position.
6.
If the handbrake cables where changed, actuate the parking brake a few times with maximum force to stretch the parking brake cables, and then control adjusting as above.
7.
Check the wheels of their free operation.
8.
Install the floor console.
9.
Test drive.
Installation
1. Installation is the reverse of removal. 2. Use a SST (09580-0U000) when installing the brake caliper assembly. ...

Rear Drum Brake
...

See also:

Delivery Pipe Installation
   • Do not use already used injector fixing clip again. ...

Console Components
1 . Floor console assembly 2 . Console upper cover [M/T] 3 . Console upper cover [A/T] 4. Potable ash tray 5 . Parking brake cover 6 . Floor console pad ...

Troubleshooting
Symptom Suspect area Remedy Engine misfire with abnormal internal lower engine noises. Loose or improperly installed engine flywheel. Repair or replace ...

Categories

Copyright www.kirmanual.com 2014-2026