Kia Rio: Power Window Motor Inspection

Front Power Window Motor Inspection

1.	Remove the front door trim panel. (Refer to the BD group - "Front door")

2.	Disconnect the connector from the motor.

3.	Connect the motor terminals No.1 and No.2 directly to battery voltage (12V) and connect the motor terminals No.6 directly to battery (-). And then check that the motor operates smoothly. If the operation is abnormal, replace the motor. [Safety Power Window]

4.	Connect the motor terminals directly to battery voltage (12V) and check that the motor operates smoothly. Next, reverse the polarity and check that the motor operates smoothly in the reverse direction. If the operation is abnormal, replace the motor. [General]

Rear Power Window Motor Inspection

1.	Remove the rear door trim panel. (Refer to the BD group - "Rear door")

2.	Disconnect the 2P connector from the motor.

3.	Connect the motor terminals directly to battery voltage (12V) and check that the motor operates smoothly. Next, reverse the polarity and check that the motor operates smoothly in the reverse direction. If the operation is abnormal, replace the motor.

Power Window Motor Circuit Diagram

...

Power Window Switch Circuit Diagram

Driver Power Window Switch Passenger Power Window Switch Rear Power Window Switch ...

See also:

Room Lamp Inspection
Room Lamp Remove the room lamp assembly then check for continuity between terminal. If the continuity is not as specified, replace the room lamp assemlby. ...

Transaxle Control Module (TCM) Installation
1. Installation is reverse of removal. In the case of the vehicle equipp ...

TPMS Receiver Diagnosis procedure by using diagnostic device
As manual for diagnosis methods by using diagnosis device, the main contents are as follows: 1. Connect self-diagnosis connector(16pins) located in the lower of driv ...

Categories

Copyright © www.kirmanual.com 2014-2026