Kia Rio: Rear Axle Assembly

BJ Boot Replacement

1. Remove the front driveshaft. (Refer to DS group - “Front Driveshaft”) 2. Remove the TJ joint assembly. (Refer to DS group - “TJ Joint”) ...

Rear Hub - Carrier Components

[Drum Type] 1. Rear torsion beam assembly 2. Brake assembly 3. Rear wheel hub assembly 4. Rear brake disc 5. Rear brake disc mounting screw ...

See also:

Component(1)
※ Installation order : A → B → C → D → E 1. Steering column shaft 2. Lighting switch 3. Wiper and washer switch 4. Screw 5. Steering angle ...

Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Specifications
Direct control VFS[35R/C] ▷ Control type : Normal low type Control Pressure kpa (kgf/cm², psi) 500.14 ~ 9.81 (5.1 ~ 0.1,72.54 ~ 1.42) Current value(mA ...

General Service Information
Protection Of The Vehicle Always be sure to cover fenders, seats, and floor areas before starting work.    The s ...