Kia Rio Manuals

Kia Rio: Rear Wheel Speed Sensor Removal - ESC(Electronic Stability Control) System - Brake System - Kia Rio UB 2012-2026 Service ManualKia Rio: Rear Wheel Speed Sensor Removal

1.
Remove the rear wheel and tire.
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
2.
Remove the rear wheel speed sensor mounting bolt (A).
Tightening torque:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)


3.
Remove the rear seat back.
(Refer to the Body group - "Seat")
4.
Remove the rear wheel housing trim.
(Refer to the Body group – "Interior trim")
5.
Disconnect the rear wheel speed sensor connector.
6.
Installation is the reverse of removal.
Rear Wheel Speed Sensor Components
1. Rear wheel speed sensor connector 2. Rear wheel speed sensor ...

Rear Wheel Speed Sensor Inspection
1. Measure the output voltage between the terminal of the wheel speed sensor and the body ground.    ...

See also:

TPMS Sensor Diagnosis procedure by using diagnostic device
As manual for diagnosis methods by using diagnosis device, the main contents are as follows: 1. Connect self-diagnosis connector(16pins) located in the lower of driv ...

Ignition Coil: Inspection
1. Measure the primary coil resistance between terminals (+) and (-). Standard value: 0.75Ω ± 15% ...

Circuit Diagram
(M/T) (A/T) ...

Categories

Copyright www.kirmanual.com 2014-2026