Kia Rio: Removal - CVVT & Camshaft - Cylinder Head Assembly - Engine Mechanical System - Kia Rio UB 2012-2026 Service ManualKia Rio: Removal

1.
Remove the cyliner head cover.
(Refer to Timing System)
2.
Remove the timing chain cover.
(Refer to Timing System)
3.
Remove the timing chain.
(Refer to Timing System)
4.
Remove the exhaust oil control valve (OCV) adapter (A).


5.
Remove the camshaft bearing caps (A) with the order below and then detach the intake camshaft and exhaust camshaft.


6.
Remove the intake CVVT assembly (A) and exhaust CVVT (B).



     
When removing the CVVT assembly bolt, prevent the camshaft from rotating by using a wrench.


[CVVT System Mode]
(1) Low Speed / Low Load (2) Part Load (3) Low Speed / High Load (4) High Speed / High Load ...

Inspection
Camshaft Assembly 1. Inspect the cam height. Using a micrometer, measure the cam height. Cam height Intake : 44.15mm (1.7382in ...

See also:

Electric Oil Pump: Removal
1. Disconnect the negative (-) battery terminal. 2. Disconnect the Electric Oil Pump (EOP) connector (A). 3. ...

DC/DC Converter: Removal and Installation
1. Disconnect the battery negative terminal. Tightening torque Without battery sensor : 7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ ...

Description
Fuel Pressure Regulator Valve is installed on the high pressure fuel pump and controls fuel flow flowing into the injectors in accordance with the ECM signal calculated based on various engin ...

Copyright www.kirmanual.com 2014-2026