Kia Rio: Removal - Engine Control Module (ECM) - Engine Control System - Engine Control / Fuel System - Kia Rio UB 2012-2026 Service ManualKia Rio: Removal


     
When replacing the ECM, the vehicle equipped with immobilizer must be performed the procedure as below.
[In the case of installing used ECM]
1.
Perform "Neutral mode" procedure with GDS. (Refer to "Immobilizer" in BE group)
2.
Insert the key and turn it to the IGN ON and OFF position.
Then the ECM key register process is completed automatically.
[In the case of installing new ECM]
-
Insert the key and turn it to the IGN ON and OFF position.
Then the ECM key register process is completed automatically.
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Disconnect the ECM Connector (A).


3.
Remove the battery (Refer to "Charging System" in EM group).
4.
Remove the mounting bolts and nut, and then remove the ECM bracket assembly (A).


Circuit Diagram
(M/T) (A/T) ...

Installation
   When replacing the ECM, the vehicle equipped with immobilizer must be performed the procedure as below. ...

See also:

Installation
   • Install the component with the specified torques. • ...

Crash Pad Components
(1) 1 . Main crash pad assembly 2 . Crash pad side cover [LH] 3 . Crash pad side cover [RH] 4 . Fuse box cover 5 . Crash pad lower panel 6 . Knee bolster panel 7 . St ...

Evaporator Temperature Sensor Inspection
1. Turn the ignition switch OFF. 2. Disconnect the evaporator temperature sensor connector. 3. Measure resistan ...

Copyright www.kirmanual.com 2014-2026