Kia Rio Manuals

Kia Rio: Removal - Clutch Pedal - Clutch System - Kia Rio UB 2012-2026 Service ManualKia Rio: Removal


     
•
Do not spill brake fluid on the vehicle; it may damage the paint if brake fluid does contact the paint, wash it off immediately with water.
1.
Disconnect the ignition lock switch connector (A) and clutch switch (B).


2.
Disconnect the push rod (B) from the clutch pedal by removing the snap pin (A) and washer.
3.
Remove the clutch pedal mounting nuts (A-4ea).
Tightening torque:
9.8 ~ 14.7 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft)


4.
Remove the clutch pedal assembly.
Inspection
Clutch Pedal Inspection 1. Measure the clutch pedal height (from the face of the pedal pad to the floorboard) and the clutch pedal clevis pin play (measured at the ...

Installation
1. Installation is in reverse order of removal. ...

See also:

Inspection
1. Turn the ignition switch OFF. 2. Disconnect the PCSV connector. 3. Measure resistance between the PCSV termi ...

DC/DC Converter: Removal and Installation
1. Disconnect the battery negative terminal. Tightening torque Without battery sensor : 7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ ...

Valve Body Components Location
1. PCV adjust screw 2. Solenoid valve 3. Oil temperature sensor 4. Accumulator 5. Low & reverse brake(LR/B) pressure flow hole 6. Under drive brake (UD/B) pressur ...

Categories

Copyright www.kirmanual.com 2014-2026