Kia Rio Manuals

Kia Rio: Removal - Clutch Master Cylinder - Clutch System - Kia Rio UB 2012-2026 Service ManualKia Rio: Removal


     
•
Do not spill brake fluid on the vehicle; it may damage the paint if brake fluid does contact the paint, wash it off immediately with water.
1.
Disconnect the push rod (B) from the clutch pedal by removing the snap pin (A) and washer.
2.
Remove the clutch pedal mounting nuts (B-3ea).
Tightening torque:
12.7 ~ 15.7 Nm (1.3 ~ 1.6 kgf.m, 9.4 ~ 11.6 lb-ft)


3.
Remove the battery and ECM.
(Refer to "Manual transaxle system" in MT group)
4.
Disconnect the clutch tube (B) and reservoir hose (A) from the clutch master cylinder.


5.
Remove the clutch master cylinder by turning it clockwise (A).
Components
1. Master cylinder 2. Ignition lock switch 3. Clutch switch 4. Pedal pad ...

Installation
1. Installation is the reverse of removal.    • ...

See also:

Vehicle Identification Number
1. World Manufacturer Identifier (WMI) - KNA : Passenger vehicle, MPV(Multipurpose Passenger Vehicle)/SUV(Sports Utility Vehicle)/RV(Recreational Vehicle) ...

Seat Heater Switch Removal
1. Disconnect the battery (-) terminal. 2. Remove the console assembly. (Refer to the BD group - "Console") ...

Waveform
This example shows a typical Crankshaft Position Sensor(CkPS) and Camshaft Position Sensor(CMPS) waveform at idle.The PCM controls the injection and ignition timing by using these sig ...

Categories

Copyright www.kirmanual.com 2014-2026