Kia Rio Manuals

Kia Rio: Removal - Brake Pedal - Brake System - Kia Rio UB 2012-2026 Service ManualKia Rio: Removal

1.
Turn ignition switch OFF.
2.
Remove the crash pad lower panel.
(Refer to the Body group - "Crash pad")
3.
Remove the shower duct (A).
4.
Disconnect the stop lamp switch connector (A).
5.
Remove the shift lock cable (B) after removing the snap pin and the clip.
6.
Remove the BCM.
(Refer to the Body Electrical group - "BCM")
7.
Remove the mounting bracket bolts (A).
Tightening torque:
9.8 ~ 14.7 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft)


8.
Remove the snap pin (A) and clevis pin (B).
9.
Remove the brake pedal member assembly mounting nuts (A) and then remove the brake pedal assembly.
Tightening torque:
16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 lb-ft)


Components
1. Brake pedal member assembly 2. Stop lamp switch 3. Pedal bushing 4. Return spring 5. Brake pedal 6. Brake pedal pad ...

Inspection
1. Check the bushing for wear. 2. Check the brake pedal for bending or twisting. 3. Check the brake pedal retur ...

See also:

Accelerator Pedal Removal
1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the accelerator position sensor connector (A). ...

Thermostat: Troubleshooting
Symptoms Possible Causes Remedy Coolant leakage • From the thermostat gasket Check the mounting ...

Inspection
1. Inspect diaphragm spring wear which is in contact with a concentric slave cylinder bearing. 2. Check the clutch cover and disc surface f ...

Categories

Copyright www.kirmanual.com 2014-2026