Kia Rio: Relay Box (Engine Compartment) Inspection

Replacement of EMS box

1.	Disconnect the negative (-) battery terminal.

2.	Push hooks in the engine room relay box out to the arrow direction and put up the EMS box assembly (A).

3.	Disconnect the connector (A) and remove the EMS box assembly (B).

Fuse Inspection

1.	Be sure there is no play in the fuse holders, and that the fuses are held securely.

2.	Are the fuse capacities for each circuit correct?

3.	Are there any blown fuses? If a fuse is to be replaced, be sure to use a new fuse of the same capacity. Always determine why the fuse blew first and completely eliminate the problem before installing a new fuse.

Multi Fuse

Multi Fuse is for optimizing the engine room package.

-	Multi fuse (A) is needed to replace entirely when there is damage to only one fuse.

-	When replace the multi fuse, refer to the "Engine compartment - component location" diagram exactly.

-	Use the multi fuse capacities for each circuit correctly.

Relay Box (Engine Compartment) Components

...

Relay Box (Passenger Compartment) Components

...

See also:

TPMS Receiver Diagnosis procedure by using diagnostic device
As manual for diagnosis methods by using diagnosis device, the main contents are as follows: 1. Connect self-diagnosis connector(16pins) located in the lower of driv ...

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the connector (A), and then remove the sensor ...

Vehicle load limit
Tire and loading information label The label located on the driver's door sill gives the original tire size, cold tire pressures recommended for your vehicle, the number of people that can be ...

Categories

Copyright © www.kirmanual.com 2014-2026