Kia Rio: Power Door Lock Actuators Inspection| 1. |
Remove the front door trim.
(Refer to the Body group - Front door)
|
| 2. |
Remove the front door latch.
(Refer to the Body group - Front door).
|
| 3. |
Disconnect the connectors from the actuator.
|
| 4. |
Check actuator operation by connecting power and ground according
to the table.
Check for continuity between the terminals in each switch position
when inserting the key into the door according to the table
[Without key (4Pin)]
[With key (6Pin)]
|
| 1. |
Remove the rear door trim.
(Refer to the Body group - Rear door)
|
| 2. |
Remove the rear door latch.
(Refer to the Body group - Rear door)
|
| 3. |
Disconnect the connectors from the actuator.
|
| 4. |
Check actuator operation by connecting power and ground according
to the table.
Check for continuity between the terminals in each switch position
when inserting the key into the door according to the table
|
Component Location
Power Door Lock Switch InspectionTroubleshooting
Symptom
Suspect Area
Remedy (Refer to page)
Water leaks from sunroof
Dirt accumulated in drain tube
Clear dirt inside of drain
Clogged drai ...
Blower Resistor (MANUAL) Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Disconnect the connector (A) and then remove the blower resistor
(B) after loosening th ...
BJ Boot Replacement
1.
Remove the front driveshaft. (Refer to DS group - “Front Driveshaft”)
2.
Remove the TJ joint assembly. (Refer to DS group - “TJ Joint ...