Kia Rio: Power Window Motor Inspection

Front Power Window Motor Inspection

1.	Remove the front door trim panel. (Refer to the BD group - "Front door")

2.	Disconnect the connector from the motor.

3.	Connect the motor terminals No.1 and No.2 directly to battery voltage (12V) and connect the motor terminals No.6 directly to battery (-). And then check that the motor operates smoothly. If the operation is abnormal, replace the motor. [Safety Power Window]

4.	Connect the motor terminals directly to battery voltage (12V) and check that the motor operates smoothly. Next, reverse the polarity and check that the motor operates smoothly in the reverse direction. If the operation is abnormal, replace the motor. [General]

Rear Power Window Motor Inspection

1.	Remove the rear door trim panel. (Refer to the BD group - "Rear door")

2.	Disconnect the 2P connector from the motor.

3.	Connect the motor terminals directly to battery voltage (12V) and check that the motor operates smoothly. Next, reverse the polarity and check that the motor operates smoothly in the reverse direction. If the operation is abnormal, replace the motor.

Power Window Motor Circuit Diagram

...

Power Window Switch Circuit Diagram

Driver Power Window Switch Passenger Power Window Switch Rear Power Window Switch ...

See also:

Component Location (2)
[4 Door] 1. Back up lamp 2. Turn signal lamp 3. Tail lamp/ Stop lamp 4. Tail lamp 5. Stop lamp 6. Side marker lamp 7. High mounted stop lamp 8. Lic ...

Manual transaxle
Manual transaxle operation The manual transaxle has 6 forward gears. This shift pattern is imprinted on the shift knob. The transaxle is fully synchronized in all forward gears so shifting to ei ...

Oil Pump Unit (OPU) Installation
1. Installation is the reverse of removal. ...

Categories

Copyright © www.kirmanual.com 2014-2026