Kia Rio: Front Washer Motor Installation

1.

Install the washer reservoir.

Before installing the pump motor, check the filter for foreign material or contamination. if necessary, clean the filter into the pump motor.

2.	Install the washer motor.

3.	Install the washer hose.

4.	Connect the washer motor connector.

5.	Install the front wheel guard (RH).

6.	Check the washer motor operation.

Front Washer Motor Removal

- When servicing the washer pump, be careful not to damage the washer pump seal. ...

Rain Sensor Circuit Diagram

...

See also:

Signal Waveform
The three waveforms below are taken from the #1 and #4 injectors. The top waveform is from the high side (feed side) of the #1 and #4 injectors, while the middle waveform is from the low side ...

Driver Airbag (DAB) Module and Clock Spring Removal
1. Set the front tires straight-ahead before removing the steering wheel. ...

Starter: Components
1. Screw 2. Front housing 3. Stop ring 4. Stopper 5. Overunn clutch 6. Lever 7. Lever plate 8. Lever packing 9. Magnet switch assembly 10. Armature assemb ...

Categories

Copyright © www.kirmanual.com 2014-2025