Kia Rio: Components Operations
ECM (Engine Control Module)
| 1. |
The ECM(PCM) (A) carries out a check of the ignition key using
a special encryption algorithm, which is programmed into the transponder
as well as the ECM simultaneously. Only if the results are equal, the
engine can be started. The data of all transponders, which are valid
for the vehicle, are stored in the ECM.
ERN (Encrypted Randorn Number) value between EMS and encrypted
Immobilizer unit is checked and the validity of coded key is decided
by EMS.
|
ENCRYPTED Immobilizer unit (A)
The Immobilizer carries out communication with the built-in transponder
in the ignition key. This wireless communication runs on RF (Radio frequency
of 125 kHz). The Immobilizer is mounted behind of the crash pad close to center
cross bar.
The RF signal from the transponder, received by the antenna coil, is converted
into messages for serial communication by the Immobilizer device. And, the received
messages from the PCM(ECM) are converted into an RF signal, which is transmitted
to the transponder by the antenna.
The Immobilizer does not carry out the validity check of the transponder
or the calculation of encryption algorithm. This device is only an advanced
interface, which converts the RF data flow of the transponder into serial communication
to the ECM and vice versa.
[USA]
[CANADA]
TRANSPONDER
The transponder (A) has an advanced encryption algorithm. During the key
teaching procedure, the transponder will be programmed with vehicle specific
data. The vehicle specific data are written into the transponder memory. The
write procedure is once only; therefore, the contents of the transponder can
never be modified or changed.
Antenna coil
The antenna coil (A) has the following functions.
| - |
The antenna coil supplies energy to the transponder.
|
| - |
The antenna coil receives signal from the transponder.
|
| - |
The antenna coil sends transponder signal to the Immobilizer.
It is located directly on the shroud.
|
Description
The immobilizer system will disable the vehicle unless the proper ignition
key is used, in addition to the currently available anti-theft systems such
as car alarms, the immobilizer system ai ...
Replacement
Problems And Replacement Parts:
Problem
Part set
Scan tool required?
All keys have been lost
Blank key (4)
YES
Antenna coil unit does n ...
See also:
Shift Lever Adjustment
1.
In neutral position, disjoin select cable (A) from shift lever
assembly pin (B).
2.
Disconnect select adjuster (A) to an arrow.
...
Hazard Lamp Switch Removal
1.
Disconnect the negative (-) battery terminal.
2.
Using a screwdriver or trim remover, remove the hazard lamp switch
(A).
...
Disassembly
1.
Remove the rear cover (A) after removing nuts.
2.
Remove the mounting bolts (A) and the brush holder assembly (B).
...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2026 Owners Manual
- Kia Rio YB 2017-2026 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2026