Kia Rio: Antenna Coil Removal

1.	Disconnect the negative (-) battery terminal.

2.	Remove the crash pad lower panel. (Refer to the BD group - "Crash pad")

3.	Disconnect the 6P connector (B) after loosening the screw and then remove the antenna coil (A).

Immobilizer Control Unit Installation

1. Install the immobilizer unit. 2. Connector the immobilizer unit. 3. Install the crash pad lower panel. ...

Antenna Coil Installation

1. Install the antenna coil. 2. Connect the antenna coil connector. 3. Install the crash pad lower panel. ...

See also:

Trouble Symptom Charts
Trouble Symptom 1 Trouble Symptom 2 Trouble symptom Probable cause Remedy The set vehicle speed varies greatly upward or downward "Surgin ...

Back-up Lamp Switch Description
Back up lamp switch is pushed by the reverse lug sliding when select arm, and switches the back up lamp. ...

Input Speed Sensor Inspection
1. Check signal waveform of Input & output speed sensor using the GDS. Specification: Refer to "Signal Wave Form" section. ...

Categories

Copyright © www.kirmanual.com 2014-2026