Kia Rio: Oil Pressure Switch: Inspection
| 1. |
Check the continuity between the terminal and the body with an
ohmmeter. If there is no continuity, replace the oil pressure switch.
|
| 2. |
Check the continuity between the terminal and the body when the
fine wire is pushed. If there is continuity even when the fine wire
is pushed, replace the switch.
|
| 3. |
If there is no continuity when a 49.0kpa (0.5kg/cm², 7.1psi) is
applied through the oil hole, the switch is operating properly.
Check for air leakage. If air leaks, the diaphragm is broken.
Replace it.
|
Oil Pan: Installation
1.
Install the oil pan.
(1)
Using a razor blade and gasket scraper, remove all the
old packing material from the gasket surfaces.
...
See also:
SS-A Solenoid Valve(ON/OFF) Circuit Diagram
...
Signal Waveform
The three waveforms below are taken from the #1 and #4 injectors. The
top waveform is from the high side (feed side) of the #1 and #4 injectors, while
the middle waveform is from the low side ...
Sunroof
If your vehicle is equipped with a sunroof, you can slide or tilt your sunroof
with the sunroof control lever located on the overhead console.
The sunroof can only be opened, closed, or tilted wh ...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2026 Owners Manual
- Kia Rio YB 2017-2026 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2026