Kia Rio: Inspection - Intake Air Temperature Sensor (IATS) - Engine Control System - Engine Control / Fuel System - Kia Rio UB 2012-2025 Service ManualKia Rio: Inspection

1.
Turn the ignition switch OFF.
2.
Disconnect the IATS connector.
3.
Measure resistance between the IATS terminals 3 and 4.
4.
Check that the resistance is within the specification.

Specification: Refer to “Specification”

Circuit Diagram
(M/T) (A/T) ...

Crankshaft Position Sensor (CKPS)
...

See also:

26 Brake Control Solenoid Valve(26/B_VFS) Specifications
Direct control VFS[26/B] ▷ Control type : Normal low type Control Pressure kpa (kgf/cm², psi) 9.81 ~ 500.14 (0.1 ~ 5.1, 1.42 ~ 72.54) Current value(mA ...

Air bag collision sensors
(1) SRS control module (2) Front impact sensor (3) Side impact sensor WARNING - Air bag sensors Do not hit or allow any objects to impact the locations where air bag or sensors are installed ...

ECM Problem Inspection Procedure
1. TEST ECM GROUND CIRCUIT: Measure resistance between ECM and chassis ground using the backside of ECM harness connector as ECM side check point. If the problem is fo ...

Copyright www.kirmanual.com 2014-2025