Kia Rio: Component Replacement After Deployment
Before doing any SRS repairs, use the GDS Pro to check for DTCs.
Refer to the Diagnostic Trouble Code list for repairing of the related
DTCs. Check and repair all DTC's before replacing a faulty or one whose
airbag system has been deployed SRSCM.
|
When the front airbag(s) deployed after a collision, replace the following
items. Make sure all DTC's are repaired befor replacing with new SRSCM.
| - |
SRSCM
|
| - |
Deployed airbag(s)
|
| - |
Seat belt pretensioner(s)
|
| - |
Anchor pretensioner(s)
|
| - |
Front impact sensors
|
| - |
SRS wiring harnesses
|
| - |
Inspect the clock spring for heat damage.
If any damage found, replace the clock spring.
|
When the side/curtain airbag(s) deployed after a collision, replace the
following items.
| - |
SRSCM
|
| - |
Deployed airbag(s)
|
| - |
Side impact sensor(s) for the deployed side(s)
|
| - |
SRS wiring harnesses
|
After the vehicle is completely repaired, confirm the SRS airbag system
is OK.
| - |
Turn the ignition switch ON; the SRS indicator should come on
for about six seconds and then go off.
|
Warning Lamp Activation
Warning Lamp Behavior after Ignition
On
As soon as the operating voltage is applied to the SRSCM ignition input,
the SRSCM activates the warning lamp for a LED lamp check.
T ...
Components
1. Driver Airbag (DAB)
2. Steering Wheel
3. Clock Spring
4. Seat Belt Pretensioner (BPT)
5. Pressure Side Impact Sensor (P-SIS)
6. Side Impact Sensor (SIS)
7. Side Airbag ...
See also:
Hands free mic Inspection
1.
Disconnect the negative(-) battery terminal.
2.
Remove the roof trim.
(Refer to the BD group - "Roof trim")
...
TPMS Receiver Replacement
When the receiver first arrives for replacement:
1)
It will be in Virgin State.
...
Component Location
1. PCB fuse & relay box (Head lamp low/ hi, Fuel pump #1, HAC,
Engine control, Front wiper, Rain sensor, Blower, Cooling fan low/ hi, Horn,
Buglar alarm horn, Start relay)
...
Copyright © www.kirmanual.com 2014-2024