Never attempt to measure the circuit resistance of the airbag
module (squib) even if you are using the specified tester. If the circuit
resistance is measured with a tester, accidental airbag deployment will
result in serious personal injury.
|
Installation
1.
Install in the reverse order of removal.
Battery sensor cable installation
bolt: 10.8 ~ 13.7 N.m (1.1 ~ 1.4 kgf.m, 8.0 ~10.1
lb-ft)
...
Radiator: Specifications
Item
Specification
Non - Air conditioning type
Air conditioning type
Fan type
PULLER
Fan speed control
Resistor (On-Off)
...
Auto Light Sensor Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the photo & auto light sensor (A) from crash pad upper
side by using screw ( ...