Kia Rio: 5Door Projected Dimensions


Front side member tooling hole (Ø6.6)	Front side member tooling hole (Ø6.6)	Side cover mounting hole (Ø8.6)

Sub frame mounting bolt	Front side member tooling hole (Ø11)	Center floor side member tooling hole (Ø10)

Center floor side member extension tooling hole (Ø6)	Rear floor side member tooling hole (Ø10)	Rear floor side member tooling hole (Ø10)

Rear floor side member tooling hole (Ø10)	Rear floor side member tooling hole (Ø8)	Rear floor side member tooling hole (Ø25)

5Door Rear Body

Side outer panel rear corner Tail gate hinge mounting hole (Ø14) Tail gate hinge mounting hole (Ø1 ...

5Door Actual-Measurement Dimensions

Front side member tooling hole (Ø6.6) Front side member tooling hole (Ø6.6) Side cover mounting hol ...

See also:

Installation
1. Install in the reverse order of removal. Battery sensor cable installation bolt: 10.8 ~ 13.7 N.m (1.1 ~ 1.4 kgf.m, 8.0 ~10.1 lb-ft) ...

Teaching Procedures
1. Key Teaching Procedure Key teaching must be done after replacing a defective ECM or when providing additional keys to the vehicle owner. The procedure st ...

Inspection
1. Inspect diaphragm spring wear which is in contact with a concentric slave cylinder bearing. 2. Check the clutch cover and disc surface f ...

Categories

Copyright © www.kirmanual.com 2014-2026