Be sure to install the harness wires so they will not pinch or
interfere with other parts.
|
|
1. |
Remove the ignition key from the vehicle.
|
2. |
Disconnect the battery negative cable and wait for at least thirty
seconds.
|
3. |
Install the new seat back assembly.
(Refer to the Body group - "Seat")
|
4. |
Install the front seat assembly.
(Refer to the Body group - "Seat")
|
5. |
Recline and slide the front seat forward fully, make sure the
harness wires are not pinched of interfere with other parts.
|
6. |
Reconnect the battery negative cable.
|
7. |
After installing the side airbag (SAB), confirm proper system
operation:
|
A/C Pressure Transducer Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Recover the refrigerant with a recovery/charging station.
3.
...
Specification
Pressure
[kPa (kgf/cm², psi)]
Output Voltage (V)
20.0 (0.20, 2.9)
0.79
46.7 (0.47, 6.77)
1.84
101.3 (1.03, 14.7)
4 ...
Inside rearview mirror
Adjust the rearview mirror so that the center view through the rear window is
seen. Make this adjustment before you start driving.
Do not place objects in the rear seat which would interfere with y ...