Kia Rio: Smart key unit Installation - Smart key System - Body Electrical System - Kia Rio UB 2012-2025 Service ManualKia Rio: Smart key unit Installation

Smart Key Unit
1.
Install the smart key unit.
2.
Install the smart key unit mounting nuts and connector.
3.
Install the negative (-) battery terminal and check the smart key system.
Interior 1 Antenna
1.
Install the interior 1 antenna.
2.
Install the heater & A/C controller.
3.
Install the negative (-) battery terminal and check the smart key system.
Interior 2 Antenna
1.
Install the interior 2 antenna.
2.
Install the console.
3.
Install the negative (-) battery terminal and check the smart key system.
Trunk Antenna
1.
Install the trunk antenna.
2.
Install the trunk transverse trim.
3.
Install the negative (-) battery terminal and check the smart key system.
Exterior Bumper Antenna
1.
Install the exterior bumper antenna.
2.
Install the rear bumper.
3.
Install the negative (-) battery terminal and check the smart key system.
Buzzer
1.
Install the buzzer.
2.
Install the left side wheel guard.
3.
Install the negative (-) battery terminal and check the smart key system.
Trunk Lid Open Switch
1.
Install the trunk lid open switch.
2.
Install the trunk trim.
3.
Install the negative (-) battery terminal and check the smart key system.
Door Outside Handle
1.
Install the outside handle.
2.
Install the door trim.
3.
Install the negative (-) battery terminal and check the smart key system.
Smart key unit Removal
Smart key unit [USA] 1. Disconnect the negative(-) battery terminal. 2. Remove the smart key unit (A) after disconnecting the c ...

Keyless Entry And Burglar Alarm
...

See also:

Coolant: Refilling And Bleeding
   Never remove the radiator cap when the engine is hot. Serious scalding could be caused by hot fluid under high pressure ...

Inspection
Front Door Lock Actuator and Switch 1. Remove the front door trim. (Refer to the Body group - Front door) 2. Remove the front door l ...

Removal
1. Remove the fuel pump. (Refer to Engine Control/Fuel System - “Fuel Pump”) 2. Remove the ORVR valve (A) after releasing hooks (B). ...

Copyright © www.kirmanual.com 2014-2025