1. |
Remove the front door trim panel.
(Refer to the BD group - "Front door")
|
2. |
Remove the front speaker (A) after loosening 3 screws.
|
1. |
Remove the rear door trim panel.
(Refer to the BD group - "Rear door")
|
2. |
Remove the rear speaker (A) after removing 3 screws.
|
1. |
Remove the front pillar trim (A).
|
2. |
Remove the tweeter speaker (A) after disconnecting the connector
and loosening 2 screws.
|
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Turn the ignition switch ON.
3.
Measure the output volt ...
Defroster
CAUTION - Conductors
To prevent damage to the conductors bonded to the inside surface of the rear
window, never use sharp instruments or window cleaners containing abrasives to clean
the window. ...
Brake Switch Inspection
1.
Connect a circuit tester to the connector of stop lamp switch,
and check whether or not there is continuity when the plunger of the
stop lamp switch is pushed in an ...