Kia Rio: Starter: Components

1. Screw
2. Front housing
3. Stop ring
4. Stopper
5. Overunn clutch
6. Lever
7. Lever plate
8. Lever packing
9. Magnet switch assembly

10. Armature assembly
11. Yoke assembly
12. Brush (-)
13. Brush holder
14. Brush (+)
15. Rear bracket
16. Through bolt
17. Screw

Starter: Specification

Starter [Non-ISG type] Item Specification Rated voltage 12 V, 0.9 kW The number of pinion teeth 10 Performance [No-load, 1 ...

Starter: Circuit Diagram

...

See also:

Blower Resistor (MANUAL) Replacement
1. Disconnect the negative (-) battery terminal. 2. Disconnect the connector (A) and then remove the blower resistor (B) after loosening th ...

Overhead Console Lamp Inspection
Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the overhead console lamp assembly. ...

Component Location (3)
[5 Door] 1. Back up lamp 2. Turn signal lamp 3. Tail lamp/ Stop lamp 4. Tail lamp 5. Stop lamp 6. Side marker lamp 7. High mounted stop lamp 8. Lic ...

Categories

Copyright © www.kirmanual.com 2014-2026